Using DMA can increase the maximum bit rate from 2 mbps to 4 mbps.Ĭheck to allow the software to release the extra system resources used by the custom driver while the printer is busy. Use ECP (Enhanced Capabilities Mode) for the fastest possible transmission speed.ĮPP (Enhanced Parallel Port) is not as fast, but may be more compatible. The following settings enable when the custom driver is in use: Performance diminishes, but reliability may enhance. Whenever possible, the software uses a custom LPT driver to increase the performance of the LPT port.Ĭheck to allow the software to use the standard Windows LPT driver instead. The software tests the printer for a connection before printing the job. The size of the transmission buffer in bytes. This port is rather uncommon today but might still be needed for some older printers
CHANGE PRINTER PORTS SERIAL
In addition to the standard serial port controls for bits per second, data bits, parity, stop bits and hardware/software flow control, there are checkboxes which enable/disable the following wires: Outputs to a file in the specified folder using a naming convention specific to the output device. The default folder in which output files are placed. The following settings are available:Ĭheck to allow the software to prompt you to provide a filename for the output file when each job is saved to a file.Ĭheck to enter the file extension you want to use for the output file in the space provided. The File port allows you to save the output data as a file.
CHANGE PRINTER PORTS INSTALL
Be sure to install the proper drivers when using these ports. USB drivers are provided with output devices that support them. Not all printers support this.Ĭlicking test will send a ping command to the device to test the connection. Select from the list or enter a custom number.Ĭlicking this button will perform a search in your network for all printers. The port number used for printing to the output device. The TCP/IP address of the output device (required). This is the most common port for printers today and several cutters are also supporting network connections Use this port if your output device supports network connection. By default, the standard port for the device is selected, but you may still need to enter or edit some of the port settings. Only the ports usable by the output device are listed. Ports are listed in order of popularity for each device. The Settings section of this window changes depending on the port used to connect to the output device.
To access the Change Port dialog, do one of the following:
0 kommentar(er)
